ScriptE for iPad: Overlay Qtake for Screengrabbing
1. Connect to Qtake WiFi
1. Connect to the Qtake WiFi. Ask your video crew for help if you need to.
Make sure you have the Qtake app open so that it shows up in the iPad Dock.
2. Start Qtake overlay in ScriptE
2. Swipe up from the bottom of the screen to reveal the iPad dock.
3. Hold down on the Qtake app and drag it upwards
4. Keep draggin the Qtake app until it looks like this, and then let go.
5. Qtake will now be overlayed on ScriptE.
Since we didn't have an active Qtake signal when creating this guide, it will only show empty camera slots.
3. Roll take with overlay
6. While the overlay is active, click TAKE to start rolling a take.
7. During the take, tap on the Qtake overlay to take screenshots of each camera.
8. Click CUT to cut the take.
9. Swipe on the three dots at the top of the Qtake overlay to send it to the side.
10. Enter take comments as usual and click DONE to dismiss the clip notes window.
11. Swipe from the side to bring the overlay back.
4. Tip!
Tip: Tip! You can use the three dots in the top of the overlay to grab the overlay and push it to the left hand side of the screen as well.
